Shooters wishing to add Z-axis isolation to their motorized three-axis gimbal setup can wear the medium GLINK Vest and Arm Stabilization System from FLOWCINE. Its dual spring-loaded arms support a semicircular carbon fiber ring that serves as the mounting point for your gimbal and monitors. The movement damping technology is based on the same design as the xARM, using a set of spring cores to fine-tune the amount of resistance between 16 and 40.5 lb.

The GLINK comes with a set of essentials and extras that allow you to operate a wide variety of camera rigs, including two sets of spring cores, an xSPINE case, a GLINK case, and a docking station.

Weight Transferred to Torso

The medium GLINK is designed to transfer the rig's weight to the shooter's torso and hips, freeing the hands to make finely calculated camera movements. The xSPINE Vest is fully customizable for men and women who shoot either regular or goofy.

Z-Axis Stabilization

Footsteps are smoothed out by vertical movement isolation technology. The spring cores in the GLINK arms provide a gentle resistance that is coordinated with the weight of the rig, enabling your camera to float as smoothly as possible.

Mount onto the Semicircular Carbon Fiber Ring

The semicircular carbon fiber ring is designed to support gimbals like the MoVI Pro and the DJI Ronin 2, which can be centered in the ring or attached in various configurations for higher camera angles. The GLINK can also work with other types of electronic heads or be used without a gimbal via the handheld mount (available separately).

Wide Range of Motion

The linear boom range offered by the rear retraction brackets enables the operator to push the camera up to eye level or towards the floor for low-angle shots. The neutral point of the rig can be balanced in either a high, overslung position or a low, underslung resting position for maximum comfort and control.